Ankle Wrap - GameReady

£488.40 (incl. VAT)

Shaped like a rising sock, this wrap delivers cold and compression from the top of the ankle down to the arch of the foot. It is a highly effective treatment for ankle sprains, acute tendinopathy, and inflammation of the arch of the foot. Easy to apply: it is laid flat on the floor, the foot is slipped inside, and the wrap is then connected to the control unit. Available in two sizes: Large (US men's size 11 and below, EU 44–45 and below) and Extra Large (US men's sizes 12 to 18, EU 46 to 53.5).

This accessory plugs in and works only with the Gameready central unit.

Size selection

Reference : GRY_590330

CUSTOMER SERVICE

at your service Monday to Friday from 9:00 am to 5:00 pm

PAYMENT

100% SECURE

Description

Description

Ankle wrap - GAME READY

The ankle wrap is like a rising sock that applies the GAME READY effect from the top of the ankle to the tip of the arch.

This is a highly effective way of treating ankle sprains, acute tendinopathy or inflammation of the arch of the foot.

Existe en deux tailles, L et XL :

Size Large (L) corresponds to men's shoe size 11 and below in the USA (44 to 45 and below in Europe).
Extra large (XL) corresponds to men's shoe sizes 12 to 18 in the USA (46 to 53.5 in Europe).

Before Initial Use : Prime the Wrap using the following steps : with the GRPro* 2.1 Control Unit off, attach the Connector Hose to the Control Unit and the Wrap. Lay the Wrap open and flat next to the Control Unit (not on the body). Turn the System on and run for 2 minutes with No Pressure

Ankle Wrap Application :

1- Put the Ankle Wrap on by first placing it flat on the floor, placing the foot of the affected ankle as shown above.

2- Wrap the the sides around the leg toward the front as shown above.

3- Ensure that the Ankle Wrap has been applied uniformly against the foot and leg with a close and snug fit around the ankle.

4- Attach the Wrap to the Control Unit with the Connector Hose. There should be an audible “click”. To disconnect, simply press the blue or gray button and remove the connector from the Wrap.

Installation of the ankle wrap on video :